HVAC Repair in Port Angeles, WA
If your system quits, tell us what it's doing and a licensed contractor who covers Clallam County will get in touch.
Tell us about the job
It takes about a minute.
Heat that never gets a break
Your furnace runs every month of the year here. Winter nights average 33°F from December through February, cold enough that the burner cycles on and off for hours at a stretch, but never so cold that it can just run flat out and rest less often. That kind of steady, moderate demand puts wear on the igniter and the flame sensor before most owners think to check them.
Most homes in the area heat with electricity, so when the power goes out, the heat goes with it. Around a quarter of Washington households lost power for a full day or more in 2024. A furnace or heat pump that seems to be working fine can fail to restart on its own once power comes back, and the house stays cold until someone resets it.
- 33°F
- the average winter night it heats against
- 67°F
- the average summer afternoon it cools against
Washington requires contractors to register with the state.
Registration puts the business on file with the Department of Labor and Industries, along with proof of a bond and insurance. Nobody tested this contractor on how to work on a furnace or an air conditioner to get that number, and the state does not track trade experience behind it. It tells you the business is legally set up to work in Washington. It does not tell you who is good at the job.
For this repair, that registration is what exists. There is no state trade exam standing behind the person doing the work, and no license number that means they were tested on furnaces or air conditioners. Washington's protection here is the record of who is registered to do business, not a judgment on their skill at the job.
Source: Washington State Legislature
- Why is my heat not working?
- Most often it comes down to power, gas, or airflow. If your thermostat screen is blank, check the breaker first. If the furnace runs but blows cold air, the igniter or flame sensor may have failed, and a dirty filter can also starve the burner of airflow and trip a safety switch that shuts the whole system down. With winter nights here averaging 33°F, a furnace that short cycles or won't stay lit needs a contractor to look at the ignition system before the next cold night.
- Why is my system running but not cooling the house?
- If the blower runs but the air isn't cold, the problem is usually with the outdoor unit, the refrigerant charge, or the coil. A coil caked with dust blocks airflow across it, and low refrigerant means the system can move air without actually cooling it. Check that the outdoor unit isn't blocked by leaves or debris, then check your filter. If both are clear and the house still isn't cooling, a contractor will need to check the refrigerant charge and the coil.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it's set to heat or cool as needed and that the batteries aren't dead. Next check your breaker panel for a tripped breaker, since 85.6% of homes here heat with electricity and a tripped breaker will stop the system cold. Then pull the filter and hold it up to a light. If you can't see light through it, replace it, since a clogged filter can cause both weak airflow and safety shutoffs. If the system still isn't working after these checks, a contractor will need to diagnose it directly.