A grey residential air-conditioning condenser unit mounted on a concrete pad beside a house, photographed at sunset.

Heat Pump Installation in Aberdeen, WA

Tell us about the house, and a licensed contractor who covers Grays Harbor County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An outdoor HVAC condensing unit on a concrete pad next to a beige single-story house with a dark shingle roof.

Ten months of the year, your heat pump is the only thing standing between you and the cold

Aberdeen doesn't get brutally cold, winter nights average 34°F from December through February, but the season runs long. Homes here need heat from September through June. That's ten months of the year your heat pump has to work, with almost no break.

A heat pump installed here has to hold up to that kind of use, not just survive a few cold snaps. If it was manufactured this year or later, a split system has to meet federal minimums of 14.3 SEER2 for cooling and 7.5 HSPF2 for heating. With most homes in the area heating with electricity, keeping that heat pump running matters even more when the power goes out. Nearly a quarter of Washington households lost power for at least a day in 2024.

10 months
September through June, your system heats
34°F
the average winter night it heats against
71°F
the average summer afternoon it cools against
Isometric line illustration of a cutaway single-story house showing interior rooms with ducted air distribution, an indoor air handler, furniture, and an outdoor condenser unit connected by lines outside the wall.

Washington requires contractors to register with the state.

That registration puts the business on file with the state and shows they carry the bond and insurance the state requires. Nobody tested their work to get that number. It is a record, not a credential.

For a heat pump installation, the protection here comes from the permit. In most cities and counties in Grays Harbor, putting in a heat pump requires a permit from the local building office, and the work gets inspected once it's done. That inspection is what checks the installation itself, not the registration.

Source: Washington State Legislature

Is a heat pump better than a furnace?
For most homes here, yes, because a heat pump also cools the house and a furnace only heats it. A heat pump moves heat instead of burning fuel to make it, so it can replace both a furnace and an air conditioner with one system. Most homes here already heat with electricity, so switching to a heat pump usually means no new fuel line or venting to worry about. The right choice still depends on the house, so a contractor should look at what you have now before you decide.
What's the difference between a heat pump and an air conditioner?
An air conditioner only moves heat out of your house. A heat pump does that same job in summer, but it can also run in reverse and move heat into your house in winter. The parts outside look almost the same, but the heat pump has a reversing valve that lets it switch direction. That's what lets one unit heat and cool instead of just cool.
Does a heat pump work in cold weather?
Yes. A heat pump pulls heat from outside air even when it's cold, because there's still heat in the air until it gets far below freezing. Winter nights here average 34°F, which is well within the range a heat pump is built to handle. Current federal minimums require split-system heat pumps to meet 7.5 HSPF2 for heating, a rating that already accounts for cold-weather performance. A contractor can size the unit to your house so it keeps up on the coldest nights you actually get.