HVAC Repair in Bremerton, WA
If your system quits, tell us what it's doing and a licensed contractor who covers Kitsap County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat, and a grid that doesn't always hold
In Bremerton, the furnace runs from September through June. That is ten months of cycling on and off, night after night, with winter lows averaging 35°F. Every one of those starts puts a little more wear on the igniter and the parts that control the burner. When one of them finally gives out, it happens on a cold night, not a warm one.
Most homes here heat with electricity, and the power does not always stay on. Statewide, close to a quarter of households lost power for a full day or more in 2024. A heat pump or an electric furnace does nothing during an outage like that, and when the power comes back, most systems restart on their own. If yours does not, that is worth a call. Summers stay mild, with afternoons around 74°F, so it is the winter side of the system that does most of the work and takes most of the wear.
- 10 months
- September through June, your system heats
- 35°F
- the average winter night it heats against
- 74°F
- the average summer afternoon it cools against
Washington requires contractors to register with the state.
That registration puts the business on file with Washington's Department of Labor and Industries. It does not mean anyone tested this contractor on how to repair a heating and cooling system. The number confirms the business exists, not that the state checked their trade skill.
So on this job, the registration is not what stands behind the technical work itself. Gas repair carries its own risk. A bad connection is the dangerous part of the job, and that risk does not go away because the business has a registration number on file.
Source: Washington State Legislature
- Why is my heat not working?
- Start with the thermostat. Check that it's set to heat and the temperature is above room temperature, and swap the batteries if it has any. If that's not it, check your breaker panel for a tripped switch, since a furnace or heat pump that loses power will just sit dead. Gas furnaces also have a pilot or igniter that can fail, so if you hear the blower running but get no warm air, that's likely the problem and it needs a contractor to look at it. With winter nights here averaging 35°F, a furnace that's out for even a day is worth getting looked at quickly.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow through the coil, and the system will run without pulling much heat out of the air. If the filter is clean, check that the outdoor unit isn't blocked by leaves, dirt, or grass clippings, since it needs open airflow to release the heat it's pulling from inside. If the air coming out feels only slightly cool or the outdoor unit isn't running at all, that points to something inside the system, like low refrigerant or a failed component, and that's a job for a contractor.
- What can I check before calling for HVAC repair?
- Check the thermostat settings and batteries, then check your breaker panel for anything tripped. Next, check the air filter and replace it if it's gray or clogged, since restricted airflow causes problems that look like bigger failures. If you have a gas furnace, see whether the pilot light or igniter display shows a fault code, most panels list one. Write down what you find and any sounds or smells you noticed. That gives a contractor a head start on diagnosing the actual problem instead of starting from scratch.